Reliable Go-Karts          


Speed Sensor, electric motor, CW-48

$62.89

Speed sensor for electric motor on Chuck Wagon CW-48 (and Landmaster).

Symptoms:  UTV takes off, but within a few seconds drops to about 1 mph.  Turning the ignition switch off and on resets it, but it does the same thing again as soon as you when you hit the accelerator pedal.

Diagnosis:  Remove the plastic cover from the control panel (behind the batteries) and read the flashing light display on the controller.  There will be a long pause, one flash, short pause, 3 flashes, and then it repeats (code 13).  This code is cleared when you turn off the ignition, so if you turned it off (which you should) to remove the cover, you'll have to re-activate the problem (drive it again) to get the code.

The speed sensor is on the left side of the electric motor, behind one of shocks.  Check the connector;  if everything looks okay, it's probably the speed sensor.

This is not intended to be a "catch-all" diagnosis and is to be used as a guideline only;  it is not a guarantee of diagnosis and/or resolution to your problem.  However, it's our experience that speed sensors have to be replaced at least once a year.


Add to Cart:

  • Model: 2-20121
  • Manufactured by: Brister's Design & Mfg.


This product was added to our catalog on Wednesday 13 February, 2013.

Your IP Address is: 54.166.130.157
Copyright © 2018 Reliable Go-Karts. Powered by Zen Cart
Parse Time: 0.072 - Number of Queries: 142 - Query Time: 0.013671055053711